Article ID 000002351; Date Published 11/6/2016; Date Last Updated. Nikon Product Manuals available for download. Nikon Product Manuals available for download. D1 AFS NIKKOR 80-400mm f/4.5-5.6G ED VR AF-S DX Nikkor 18-300mm f/3. Fahren Lernen Plus Serial Keygen Patch. 5-6.3G ED VR AF Zoom-Nikkor ED 80-200mm f/2.8D.
ERROR 03 is a grade circle reading error. The grade system uses an etched glass circle, the same as a digital Theodolite or total station uses, to measure it's grade.
If there is a problem with the readings of the circle then values have been lost telling the circuits how to read that exact circle properly, or something has become damaged. I've seen a number of them where the circle was intact, however no longer attached to the axis shaft it is supposed to be permanently fixed to. The user manual says to turn the unit off and back on, to see if it was just a momentary glitch. I would also remove the battery and external power for a few minutes before I turned it back on. Unfortunately, if that doesn't solve the problem the signals are going to have to be realigned, and parts may have to be replaced.
In order to realign the signals, a standalone power supply is needed, as well as a digital oscilloscope and Topcon tolling, called 'illuminators'. Aug 28, 2014 .
The lock on almost any Digital Theodolite or non-robotic total staton is very similar. It's an rotating shaft with an side ways egg shape at the end. As you turn the knob the oblong end pushes on a pin or some sort of friction device that is attached to the axis.
Often what will happen is either the position of the lock shaft moves, so it reaches a limit before enough friction is applied to the axis. Or some part of the lock is jammed and is not pushing into the axis.
It should be visible behind the display, and there should be 2 set screws on the bottom of the instrument below the lock (on the outside, not behind the screen) Most likely backing thoes off, just a little bit will give you enough movement to watch internally where you can find a new lock position, and tighen the setscrews again to hold it in place. Jul 25, 2012 .